So I am in the process of replacing the axle seal on the 330xi (front).
I removed sway bar, brake calliper (did not remove the brake holder), removed the tie rod. Now I tried removing the pinch bolt.. and guess that thing started cracking and its as good as snapped...
Now I get quite a bit more room to move the knuckle left and I hammered out the axle and they are nearly out.. but I can't get it just a tad bit more to pop out.
Do I need to remove the strut thing to get the room? Can the axle be removed with just the tie rod popped off?
What about the lower control arm ball joint, there is simply no room to put a tie rod remove on there to get it to pop off the knuckle.. so how does one remove that suck because would that give me enough room?
I removed sway bar, brake calliper (did not remove the brake holder), removed the tie rod. Now I tried removing the pinch bolt.. and guess that thing started cracking and its as good as snapped...
Now I get quite a bit more room to move the knuckle left and I hammered out the axle and they are nearly out.. but I can't get it just a tad bit more to pop out.
Do I need to remove the strut thing to get the room? Can the axle be removed with just the tie rod popped off?
What about the lower control arm ball joint, there is simply no room to put a tie rod remove on there to get it to pop off the knuckle.. so how does one remove that suck because would that give me enough room?
Aucun commentaire:
Enregistrer un commentaire