Hi All,
I just spent the past 5 hours replacing one rear coil spring and a strut mount :banghead:. The hope were to replace both rear springs, both RTABS, and both strut mounts. However I ran into an issue that I wasn't able to figure out and am hoping you can shed some light. My Trailing Arm would NOT lower enough to even get the bolt out of the console. I tried everything I could see or think of to get this thing low enough to get the console off and the bushing press in. Any ideas what could have been holding it up? If this helps rule things out, even the strut was completely disconnected. Any input is much appreciated. Thanks.
I just spent the past 5 hours replacing one rear coil spring and a strut mount :banghead:. The hope were to replace both rear springs, both RTABS, and both strut mounts. However I ran into an issue that I wasn't able to figure out and am hoping you can shed some light. My Trailing Arm would NOT lower enough to even get the bolt out of the console. I tried everything I could see or think of to get this thing low enough to get the console off and the bushing press in. Any ideas what could have been holding it up? If this helps rule things out, even the strut was completely disconnected. Any input is much appreciated. Thanks.
Aucun commentaire:
Enregistrer un commentaire