In mint condition ECIS. Only used for approximately 300 miles. New costed over $450. Sold M3 already. Make reasonable offer.
The long awaited intake for your E-46 M3 is now available.
After several prototypes and dyno runs, we have an intake that gives you real horse power and torque gains. (Attached Dyno sheets were with Conforti software. We will have stock Dyno sheets posted soon)
Our kit includes our fully enclosed fiberglass heat shield to minimize engine heat soak and air turbulence.
We have also developed our own Air Flow Meter that accepts the screen from your stock air box. It is keyed so that the screen is at the proper orientation to the air mass sensor without any modifications.
Also included is our custom made conical filter made specifically for the M3 application. Our filter uses a gauze material that has deeper pleats which increases the total air filtration surface area, traps smaller (and more) particles, and provides your engine more protection. Also, this conical filter has the convex top that further increases the filtration surface area. At the bottom end, we have incorporated an internal velocity stack that increases air speed entering the intake by smoothing out the airflow (decreasing air turbulence) and thereby, increases performance.
As with all of our intake kits, it is easy to install and requires no cutting or modifications to your car. Typical install time is about 45 minutes and can be done with simple hand.
The long awaited intake for your E-46 M3 is now available.
After several prototypes and dyno runs, we have an intake that gives you real horse power and torque gains. (Attached Dyno sheets were with Conforti software. We will have stock Dyno sheets posted soon)
Our kit includes our fully enclosed fiberglass heat shield to minimize engine heat soak and air turbulence.
We have also developed our own Air Flow Meter that accepts the screen from your stock air box. It is keyed so that the screen is at the proper orientation to the air mass sensor without any modifications.
Also included is our custom made conical filter made specifically for the M3 application. Our filter uses a gauze material that has deeper pleats which increases the total air filtration surface area, traps smaller (and more) particles, and provides your engine more protection. Also, this conical filter has the convex top that further increases the filtration surface area. At the bottom end, we have incorporated an internal velocity stack that increases air speed entering the intake by smoothing out the airflow (decreasing air turbulence) and thereby, increases performance.
As with all of our intake kits, it is easy to install and requires no cutting or modifications to your car. Typical install time is about 45 minutes and can be done with simple hand.
Aucun commentaire:
Enregistrer un commentaire