Bentley doesn't have diagnostics for the window system, just R&R instructions. Hoping someone can help me pin this one down to either the switch or the GM5 module. Car is a 2005 Cic so I have the "all-windows" button.
1) All down functions work normally for front/rear windows. (one-touch\manual\all-windows).
2) Passenger front & both rears up works normally (one-touch\manual\all-windows).
3) Driver's front doesn't respond to all-windows button up.
4) Driver's front doesn't respond to first click of up...the manual up mode.
5) Driver's front runs in manual up mode when switch held in one-touch up position. IOW, it stops if switch is released from the one-touch up position.
6) I'm sure it's not a matter of resetting as I've successfully reprogrammed the passenger one-touch operation several times for various reasons.
7) Driver's side auto up/down with door open/close works properly.
A replacement switch is relatively cheap (as E46 repairs go) at $45, but I'd still hate to spend the money just to find out the problem is in the GM5 module. Any suggestions on how to narrow down the culprit. Obviously, I'm assuming motor/regulator are fine since they do appear to be operating normally once they receive a signal.
TIA.
-Brent
1) All down functions work normally for front/rear windows. (one-touch\manual\all-windows).
2) Passenger front & both rears up works normally (one-touch\manual\all-windows).
3) Driver's front doesn't respond to all-windows button up.
4) Driver's front doesn't respond to first click of up...the manual up mode.
5) Driver's front runs in manual up mode when switch held in one-touch up position. IOW, it stops if switch is released from the one-touch up position.
6) I'm sure it's not a matter of resetting as I've successfully reprogrammed the passenger one-touch operation several times for various reasons.
7) Driver's side auto up/down with door open/close works properly.
A replacement switch is relatively cheap (as E46 repairs go) at $45, but I'd still hate to spend the money just to find out the problem is in the GM5 module. Any suggestions on how to narrow down the culprit. Obviously, I'm assuming motor/regulator are fine since they do appear to be operating normally once they receive a signal.
TIA.
-Brent
Aucun commentaire:
Enregistrer un commentaire